Reloading TAURI firmware via USB Full Image

Hardware needed:
Windows PC
Micro USB cable

Software needed:
DriverAssistant: http://ftp.auroramultimedia.com/files/firmware/Tauri/old/DriverAssistant_v4.4.zip
RKDevTool: http://ftp.auroramultimedia.com/files/firmware/Tauri/old/RKDevTool.zip


Firmware Images:
TTS-10: http://ftp.auroramultimedia.com/files/firmware/Tauri/img_files/TTS10_v1_10_2.img
TTS-15: http://ftp.auroramultimedia.com/files/firmware/Tauri/img_files/TTS15_v1_10_2.img
TTS-21: http://ftp.auroramultimedia.com/files/firmware/Tauri/img_files/TTS21_v1_10_2.img


Steps:
-Extract and run DriverAssistant to install the drivers
-Extract RKDevTool to a convenient location
-Run RKDevTool
-Connect your Tauri to your PC with the micro USB cable. The correct port is under the I/O plate held on with two screws. Do not power on the device yet.
-Hold either:
1) the "Recover" button located under the I/O cover on the back of the TTS-10
2) the Volume Up and Back buttons on the TTS-15 and TTS-21
while applying power. Keep it held down for about 3 seconds. NOTE: Do not hold the button down for too long, or it will not work. If done correctly, RKDevTool should show "Found LOADER device".
-Click the "Update Firmware" Tab
-Click "Firmware" and select the .img file supplied above.
-Once it loads and shows the path in the Firmware box, click "Run".

The tablet will upgrade and auto-restart once complete.