The IBT Series AV Distribution Solution consists of two transceiver devices, IBT-1-BX (box) and IBT-1-WP1 (1 gang wall unit) are the building blocks to create up to a 255x255 low cost 4K60 4:4:4 matrix using a network switch. This is not your typical AV over IP solution. The IBT Series has the simplicity of HDBaseT with the scalability of AVoIP. We refer to this as IPBaseT®.
Here is how it works. Each unit can be set as a transmitter or receiver and can be addressed from 0 to 255. If it is point to point, set one to transmitter and another to receiver, set it to address zero and connect with CAT cabling or Fiber accordingly. If it is to be used as a distribution amplifier, set one as a transmitter and the amount required for receivers at address zero, and connect to the appropriate network switch brand and size we recommend in the documentation. To make a switch or matrix, set the devices accordingly to be transmitters and receivers, and then set the transmitters address starting at 1 and same for receivers. Now with a simple multicast or RS-232 command that is no different than an off the shelf matrix, the units will route accordingly. Yes, it is that simple.
The IBT Series is meant to only use a network switch as a matrix to “glue” the IBT devices together that is on our list of recommend switches so it will work out of the box with little setup for plug and play operation.
Important!
Aurora IBT AV Over IP Switch Recommendations and Guidelines
Aurora exclusively recommends NETGEAR 1G M4250 and M4350 Series switches for use with our IPBaseT (IBT) Series products, ensuring maximum reliability and simplified setup.
Benefits of Purchasing Netgear Through Aurora
When purchased directly through Aurora, these NETGEAR switches provide two key advantages:
- Pre-configuration: Switches will be pre-loaded with the required firmware and pre-configured to function as an IPBaseT matrix, ensuring out-of-the-box, plug-and-play operation.
- Extended Warranty: The standard 3-year warranty will be extended to 5 years (refer to the Warranty Section for details).
Network Integration and Support Policy
For optimal performance and support, Aurora strongly recommends that the IBT Series products only be connected to the customer's network for control and monitoring purposes.
Unsupported Equipment: Connecting IBT Series units to any other brand or model of switch is not supported. Aurora will not configure, adapt, or troubleshoot systems using unapproved equipment. Support for alternative network switches will have to be routed through the switch manufacturer directly. No support will be provided by Aurora.
Alternative Use Cases: If connection to a customer’s existing data network is required for the core AV distribution, we recommend utilizing the Aurora VPX 1G or IPX 10G AV over IP Series instead of the IBT Series.
NETGEAR Switch Firmware Required for Matrix Operation:
M4250 13.0.5.16 or Higher
M4350 14.0.6.9 or Higher